Ohm's Law Calculator
Enter any two of voltage, current, resistance and power — the calculator finds the other two and handles unit prefixes.
Fill in any two values and leave the other two empty; the remaining voltage, current, resistance and power are calculated.
Used as a known value.
Used as a known value.
Solved from U = I·R and P = U·I: U = 12 V, I = 2 A, R=6 Ω, P = 24 W (base units, rounded to 8 significant figures).
How to use
- Enter two known values: For example voltage and resistance. Leave the other two boxes empty.
- Pick the units: Choose V/mV/kV, A/mA/μA, Ω/kΩ/MΩ or W/mW/kW for each value.
- Read the results: The two missing values appear with sensible unit prefixes, plus the base-unit working.
Ohm's law and power formulas
U = I × R I = U / R R = U / I P = U × I = I² × R = U² / R
Voltage (U or V) pushes current (I) through a resistance (R); power (P) is the rate of energy use. Knowing any two lets you find the other two.
Example: a 12 V supply across a 6 Ω resistor drives 12 / 6 = 2 A, and the resistor dissipates 12 × 2 = 24 W — so it needs a power rating above 24 W.
Household examples: watts, amps and circuit limits
In North America homes run on 120 V, so I = P / V tells you how much current an appliance draws. A 1,500 W space heater pulls 12.5 A and a 1,875 W hair dryer about 15.6 A, which is why running both on one circuit trips the breaker. At 230 V, as in Europe and much of Asia, a 2,000 W kettle draws only about 8.7 A.
A standard 15 A circuit at 120 V carries up to 1,800 W, but continuous loads such as heaters should stay under 80%, about 1,440 W. A 20 A circuit allows 2,400 W, or 1,920 W continuous.
These sums are exact for resistive loads like heaters, kettles and toasters. Motors in fridges, air conditioners and pumps have a power factor below 1, so their watts are lower than volts × amps, and they draw a short surge of several times their running current when they start.
Frequently asked questions
- How do I calculate current from voltage and resistance?
- Divide voltage by resistance: I = U / R. 230 V across 46 Ω gives 5 A.
- How do I convert watts to amps?
- Divide power by voltage: I = P / U. A 2,000 W kettle on 230 V draws about 8.7 A; on 120 V about 16.7 A.
- How do I find resistance from voltage and current?
- R = U / I. A device that draws 0.5 A from 12 V has an effective resistance of 24 Ω.
- Does Ohm's law work for every component?
- It applies to ohmic devices such as resistors and wires at constant temperature. LEDs, diodes and transistors are non-linear, so use their datasheet values instead.
- How many watts can a 15-amp circuit handle?
- At 120 V, 15 A × 120 V = 1,800 W. For loads that run for hours, keep to 80% of that, about 1,440 W.
- What is the difference between watts and VA?
- Watts are the power actually used; VA is volts times amps. For heaters they are the same, but for motors and electronics watts are lower because of the power factor, often around 0.8–0.95.